SYNLawn artificial grass Installation Instructions
Following these steps to install your SYNLawn artificial grass, will give you a beautiful, green and worry-free lawn for years to come.
- Seaming Cloth (1 roll = 15 feet)
- Seaming Glue (1 qt. = 15 feet)
- Landscape Stakes (25 per package)
- Turf Rake (for bristle fibers)
- Hand Tamper (for outdoors applications)
- Sprinkler Caps (if needed)
- Utility Knife
- Yard Rake
- Tape Measure
- Marking Paint
- Garden Hose
- Wide Shop Broom
Prepare the base
Most outdoor applications require preparation of an aggregate base to allow proper water drainage. Simply clear the surface where your SYNLawn will be placed, removing any unwanted grass and roots.
Once clear, add a two to four-inch layer of crushed aggregate until achieving the desired shape and contour. Work the aggregate with a rake and hand tamp until the surface is compact and smooth.
Trim to size
With the base ready, position your SYNLawn and trim to shape. If using more than one roll of SYNLawn, make sure the “grain” of the grass fibers point in the same direction.
Glue together seams
To seam SYNLawn together, align two pieces of SYNLawn edge-to-edge. Fold back the edges to lay SYNLawn seaming cloth the length of the seam.
Secure in place
Secure the seaming cloth in place. Apply seaming adhesive to the cloth, spreading to a consistent thickness. After a few minutes, slowly ease the two edges back together, checking the fit as you go.
To secure your SYNLawn, use five to six-inch galvanized nails or landscape anchor pins around the perimeter and where necessary to keep your SYNLawn flat.
Groom your grass
Finally. Use a landscape rake or broom to brush the fibers up and rinse with a garden hose. Periodic brushing and rinsing will keep your SYNLawn looking fresh, natural and beautiful for years to come